aircon PARTS REPLACEMENT

The air conditioner is not an open system, but rather, a closed one.When it enters your house, the air conditioner first goes through three phases: vapour, liquid, and vapour. It is a closed system because it uses refrigerant pipes to connect to the internal components. Professional aircon parts replacement Singapore can significantly identify the problem and fix it in no time.

AIRCON PARTS REPLACEMENT SINGAPORE

When you turn on your air conditioning at the beginning of the season, you’re likely to be wondering a lot of things. The most common question concerns determining whether the air conditioner is operating properly.Our specialists would normally begin by troubleshooting the entire system to find out if there is a problem. If we identify a damaged component, we will remove it before replacing it. To find out if there is a problem with the system, we will begin by troubleshooting it. If we determine that there is a faulty component, we will replace it before proceeding.

    THE SCOPE OF WORK WHEN IT COMES TO PARTS REPLACEMENT

    Best aircon service in Singapore

    1. SWITCH OFF THE POWER

    The first step is to ensure that the electric current flowing into the home gets turned off. Find the aircon capacitor according to the manufacturer’s directions. Zealcorps offers the best aircon parts and replacement singapore

    2. OIL THE FAN MOTOR AND CLEAN THE CONDENSER FAN

    The fan on the condenser may be dusty and covered with debris. To clean it, use a brush. Only use the oil recommended by the manufacturer to oil the parts.

    3. CLEAN THE CONDENSER COILS AND FINS

    To ensure your condenser coil stays clean, you should periodically use a garden nozzle to blast water at it. Make sure you work your way around the coil to ensure you get all of the crud. Then, shoot some streams of water at the coils to ensure that you get rid of any debris.

    4. TEST THE FUSES

    Make sure to check the fuses located in the disconnect block. The correct numerical values should be obtained using a multimeter. If you get a zero reading or a negative one, you must replace the fuse.

    5. INSPECT THE INNER PART OF YOUR ACCESS PANEL

    To determine whether a capacitor is functional or not, use an insulated screwdriver to determine the capacitor’s voltage levels. If the capacitor has failed, the readings will be out of range.

    6. REPLACING THE CAPACITOR

    To replace a broken capacitor, begin by inserting a new capacitor into the retaining bracket. Once the capacitor is secure, use a zip tie to secure it.

    7. REPLACE THE CONTACTOR

    To change the contactor, you just have to pull off the old one and put in a new one. Use your screwdriver to secure it in the condensing unit.

    8. REPLACE THE FAN MOTOR

    Before you can remove the blade, you must first identify which side is up by using a marker. Next, loosen the motor shaft from the motor until it’s pulled off. Zip ties must first be used to hold the motor wire before it can be connected.

    The zip ties will keep the blades from injuring the wires that are being installed. When everything is done, replace the disconnect block and access panel. Turn the circuit breaker back on once you’ve completed this operation. You may now see whether your part replacement worked.

    ×